1- IIS Configuration

1 - To use monitor 245, you must configure Internet Information Services (IIS). You must have it installed and enable certain features (CGI, ISAPI Extension, and ISAPI Filters), as shown in the figure:

Step 2

This image represents the beginning of the installation process.
To proceed, just click next.

Step 4

Confirm the destination location as noted on the following screen and click install. Expect to complete the installation.

3 - Using Monitor245

After installation, the monitor is available at virtual address/monitor245/monitor245.dll (understand virtual address as the server ep installed on the machine).

• The first column is the server ip number installed on your machine.
• The second column represents the total number of bytes a memory or drive has.
• The third column reports the number of bytes of total memory not being used.
• The fourth column shows the same information as the third, but in percentage.
• The fifth column tells you how many bytes are being used by the computer.
• The sixth column indicates the same information as the fifth but in percentage.


The lines tell you if the reference is Physical Memory (RAM) or if any disk in your computer. Depending on whether or not your computer is partitioned, more than one drive may appear, as shown in the figure: